Log in to follow, share, and participate in this community. Question How does ONT insert 100GE SR4 FEC Loss of Alignment Marker Payload Sequence alarm? Question How does ONT insert 200GE and 400GE FEC Loss of Alignment Marker Payload Sequence alarm? Question How does ONT insert FlexO FEC Loss of Alignment Marker Payload Sequence alarm? Question What comprises the RF Over CPRI testing for the Viavi TB5800? Question How does ONT generate the 40GE and 100GE PCS HI BER alarm? Question How does ONT generate the 10GE PCS HI BER alarm? Question What is the expected optical insertion loss from an AC990 or AC991 integrating sphere? Question Why does my ONX580P only show resistance ranges of 0-99M ohms? Question What does ONT send for the 40GE/100GE PCS invalid alignment marker insertion? Question Which optical transponders does ONT MTM support for use with 8G FC? Question Can TestPoint telnet access be password protected? Question Does TestPoint serial operator port support remote control the same as telnet access? Question How do I collect hardware and software details from ONT-500 and ONT-600 mainframes and modules? Question Which CPRI rates are supported on the MTS/TB5800 testsets? INTERNAL JDSU Question Why am I unable to select all the CPRI tests in the MTS/TBERD CPRI Check? Test Selections for RRH Identification, RET, SWR, Diversity Imbalance and PIM Detection are either not there or greyed out. Question How do I add a test point compensation in my ONX-620/630? Question I am unable to use Ethernet port 1 in ONX CATV units to run Ethernet tests after updating to 3.8.6, what do I do? Question I am getting an Unexpected Application Error in StrataSync, what do I do? Question Do you know what the dwell time for the Ingress Scan/Expert application is? Question Does my ONX-610/620/630 have DOCSIS 3.0 or 3.1 hardware?